 |
|
|
 |
Turn the threaded end of the pillar, clockwise into the triangular metal base. Tighten these parts together - do not over tighten.
Place the collar on top of the pillar. Temporarily tighten one of the set screws. Do not over-tighten this screw.
 |
Run your speaker wire inside the pillar, and out the notch in the collar. Leave enough wire to connect to the speaker later on.
 |
Using the three screws supplied, attach the platform to the top of the metal collar. The metal tabs on this plate should face up.
 |
Partially install the two screws into the tabs on the platform. These screws will be tightened in Step 8.
 |
Position your speaker onto the platform.
Install the metal plates between the screws in the tabs and your speaker. Tighten the screws to secure the speaker onto the stand. Do not over-tighten these screws.
Connect your speaker wire to your speaker.
 |
Loosen the collar set screw in Step 3. Position your speaker so it faces forward. Finally, securely tighten all the collar set screws. Do not over-tighten these screws.
 |
For any additional information or service, contact:
Axiom Audio Head Office
2885 Highway 60
Dwight, ON Canada
P0A 1H0
Toll Free (North America): 1-866-244-8796
Worldwide: 1-705-635-3090
Email: info@axiomaudio.com