 |
|
|
 |
Locate the two round pillars with the threaded end and screw the threaded end carefully into the metal pedestal base, rotating the pillar in a clockwise direction. Tighten pillars right down as snugly as you can.
Now you can run the speaker cable through one of the pillars and out the top to connect to the speaker later on.
Now place the collars on top of the pillars but do not tighten the set screw. At this time set screws should be facing the rear of the stand. Speaker wire should be placed in one of the collar notches.
 |
Attach the platform to the top of the metal collars (ensure that the metal lips of the plate face upward) using the six supplied screws.
Now tighten the collar set screws.
 |
Partially install the two set screws that will move the rear platform tabs up against the speaker’s rear baffle to secure the speaker to the top plate.
 |
Now place the speaker on the platform.
Place the platform tabs between the platform set screws and the speaker then gently tighten the rear platform set screws to bring the speaker up against the metal tab at the front of the platform. Do not over tighten these screws.
Connect the speaker cable to the speaker binding posts.
 |
For any additional information or service, contact:
Axiom Audio Head Office
2885 Highway 60
Dwight, ON Canada
P0A 1H0
Toll Free (North America): 1-866-244-8796
Worldwide: 1-705-635-3090
Email: info@axiomaudio.com