Previous Thread
Next Thread
Print Thread
Rate Thread
Page 6 of 13 1 2 4 5 6 7 8 12 13
Re: My speakers arrived but...
Ichigo_Kurosaki #315773 07/20/10 09:15 PM
Joined: Sep 2008
Posts: 4,116
connoisseur
Offline
connoisseur
Joined: Sep 2008
Posts: 4,116
Originally Posted By: Ichigo_Kurosaki
How should I adjust the LFE settings on the receiver?


You might want to spend some time going through the entire product manual to get familiar with all aspects of your new receiver. It can be very intimidating at first when you buy a product with so many diffrent features. As for adjusting the LFE you will have to go into the system setup to turn on/off the subwoofer, adjust the subwoofer crossover point and choose settings for your speakers such as small, large or large + subwoofer which is more appropriately what Denon calls LFE + Mains.

As for adjusting the voltage on your new subwoofer (sub pre-out), you can access that with your remote using the CH SEL button (I hope this is the same with your receiver but I am not sure).


I’m armed and I’m drinking. You don’t want to listen to advice from me, amigo.

-Max Payne
Re: My speakers arrived but...
SRoode #315798 07/20/10 11:17 PM
Joined: Jun 2010
Posts: 463
devotee
OP Offline
devotee
Joined: Jun 2010
Posts: 463
Originally Posted By: SRoode
Many good suggestions here! I'm also surprised at the L/R front level difference (It's a HUGE difference). Check to make sure the connections are secure.

As far as the sub goes, according to Audyssey your sub is working because it is trying to attenuate the signal by 12db. I would try to fix the L/R channel problem first then re-run Audyssey again.

Also, keep in mind that you sub will be drawing about 15% more current because of running it at 100V versus 120V. Keep an eye on the power light ever now and then because you stand a better chance of blowing the sub fuse at higher listening levels.

Good Luck!


I guess I have a problem on my apartment electric wire. Sometimes while listening to music and if the light of the room were turned on or off the receiver was turning off for a couple of seconds. What could it be? It looks like it is draining more power than the receiver could supply I guess.


Believe those who are seeking the truth. Doubt those who find it.
Re: My speakers arrived but...
bdpf #315800 07/20/10 11:18 PM
Joined: Jun 2010
Posts: 463
devotee
OP Offline
devotee
Joined: Jun 2010
Posts: 463
I was watching Master and Commander and didn't feel anything on the cannon scene. lol


Believe those who are seeking the truth. Doubt those who find it.
Re: My speakers arrived but...
Ichigo_Kurosaki #315802 07/20/10 11:20 PM
Joined: Jun 2010
Posts: 463
devotee
OP Offline
devotee
Joined: Jun 2010
Posts: 463
Is it a holiday in Canada? I haven't received any answer to my e-mail yet. That does not look like a good customer support for me.


Believe those who are seeking the truth. Doubt those who find it.
Re: My speakers arrived but...
Ichigo_Kurosaki #315803 07/20/10 11:20 PM
Joined: Dec 2008
Posts: 6,928
axiomite
Offline
axiomite
Joined: Dec 2008
Posts: 6,928
You should have levitated during that scene!


Half of communication is listening. You can't listen with your mouth.
Re: My speakers arrived but...
Ichigo_Kurosaki #315804 07/20/10 11:20 PM
Joined: Aug 2009
Posts: 6,015
axiomite
Offline
axiomite
Joined: Aug 2009
Posts: 6,015
I'm supposing that, a dedicated electrical circuit is out of the question? That might help in your situation.

Re: My speakers arrived but...
CatBrat #315805 07/20/10 11:21 PM
Joined: Aug 2009
Posts: 6,015
axiomite
Offline
axiomite
Joined: Aug 2009
Posts: 6,015
I need to listen to that canon scene again. I do remember a lot of noise, but it seems to have been mostly in the mid to upper frequencies.

Re: My speakers arrived but...
CatBrat #315806 07/20/10 11:21 PM
Joined: Jun 2010
Posts: 463
devotee
OP Offline
devotee
Joined: Jun 2010
Posts: 463
Originally Posted By: CatBrat
I'm supposing that, a dedicated electrical circuit is out of the question? That might help in your situation.


What would it mean?


Believe those who are seeking the truth. Doubt those who find it.
Re: My speakers arrived but...
Ichigo_Kurosaki #315807 07/20/10 11:22 PM
Joined: Jan 2010
Posts: 578
G
aficionado
Offline
aficionado
G
Joined: Jan 2010
Posts: 578
Originally Posted By: Ichigo_Kurosaki
I was watching Master and Commander and didn't feel anything on the cannon scene. lol


I had the same problem when I got my EP500, I didn't feel good about it at all, no bass or LFE's, asked here, forgot about the "10 o'clock setting, ran an SPL meter for all speakers, then turned it up to 2PM , moved the sub to different positions till I found one and all is well!

Last edited by wordgasm; 07/20/10 11:23 PM.

Fronts/Wides:M22s in/on
Center:VP150/VP100 in/on
Hghts,SS,SR:QS8s
Sub:EP500
AVR:Onkyo 3008
Re: My speakers arrived but...
Glitchy #315808 07/20/10 11:25 PM
Joined: Jun 2010
Posts: 463
devotee
OP Offline
devotee
Joined: Jun 2010
Posts: 463
I was wondering would this receiver turn off thing be caused by my stereo speaker connected on the center channel?


Believe those who are seeking the truth. Doubt those who find it.
Page 6 of 13 1 2 4 5 6 7 8 12 13

Moderated by  alan, Amie, Andrew, axiomadmin, Brent, Debbie, Ian, Jc 

Link Copied to Clipboard

Need Help Graphic

Forum Statistics
Forums16
Topics24,990
Posts442,737
Members15,646
Most Online2,699
Aug 8th, 2024
Top Posters
Ken.C 18,044
pmbuko 16,441
SirQuack 13,851
CV 12,077
MarkSJohnson 11,458
Who's Online Now
0 members (), 548 guests, and 0 robots.
Key: Admin, Global Mod, Mod
Newsletter Signup
Powered by UBB.threads™ PHP Forum Software 7.7.4