Axiom Home Page Forums General Discussion Technical Questions Speaker wiring

Thanks for the tips. I've always used bare wire connections before but was debating which way to go. For now I think I'll go with bare wire, since I don't plan to swap my speakers out unless they're for new axioms. I also need a new cable for my subwoofer so I will definitely look at bluejeans for that.

While there are cheaper, the stock that Blue Jeans uses is top quality stuff. Plus the equipment they use for termination with RCA jacks can't be beat. I've never seen cleaner crimps than those that Blue Jeans produces.

My sub cable is from blue jeans cable and i like it a lot. It's very flexible and lies flat on the carpet and around corners nicely

my A/V receiver has both front left/right, high/wide output jacks, so the total is 3 jacks on the left and 3 jacks on the right. My question is do I need to provide a 3 sets of audio cable (black/red) on the front left and 3 sets on the front right to connect it to the front speakers?, and where's the exact location on the speakers of m80 input jacks?. I observed in the m80 v2 back photo has 2 sets of input jacks my guess is that this is high and low jacks but where is the wide jack?. Anyway, i hope you got my point, thanks in advance for understanding my questions.... Saul

Saul, you don't need to post in multiple places, and it would probably be best overall to create your own thread rather than piggybacking on others. That said, have a look at your first post for my answer.